Atlona AT HD44M SR Bedienungsanleitung

AtlonA4x4 HDMI over CAT5 Matrix with IR Control PathAT-HD44M-SRUser Manual

Supported IR Data FormatData Format Suitable Not RecommendedNEC +RC5 +TOSHIBA MICOM CODE +GRUNDIG CODE +SONY 12 BIT CODE +SONY 15 BIT CODE +SONY 20 BI

8 9 AT-HD44M-S as master:1. Connect all sources to

OPERATION and IR CONTROLSource SideMethod A: Push Button Push the switch button on the front panel, the source will be sequentially changed.Method

10 11 Display SideMethod A: Push button Push the

RS-232 SERIAL PORT CONTROLRS-232 transmission FormatBit Rate: 9600Data Bits: 8Parity: NoneStop bits: 1Flow Control: NoneSet CommandThe command set i

FIRMWARE UPDATE13Warning!There could be unexpected consequences resulted from inappropriate firmware update operation. Please do it with caution.1. Pl

7. Please make sure your PC has direct connection to the RS-232 port of the MATRIX, as shown in the picture (left), that in [Communication Setting] th

NOTICE14 15 1. If the DVI or HDMI device requires

SAFETY INFORMATION16 SafeguardsTo reduce the risk of electric shock, do notexpose this product to ra

16 17 WARRANTYLIMITED ONE-YEAR WARRANTYATLONA by

TABLE OF CONTENTS1. Introduction ... 12. Features ...

INTRODUCTION 1 The AT-HD44M-SR 4x4 HDMI over CAT5

SPECIFICATIONSTechnical AT-HD44M-S AT-HD44M-RRole of usage True 4x4 matrix & transmitter [TX] Receiver [RX]HDMI compliance HDMI 1.2aHDCP compli

2 3 1. 1x AT-HD44M-S2. 1x IR emitter cable13. 2x

AT-HD44M-SFront Panel1. Power: Power indicator LED2. IR: IR receiver3. Input: Input source indicator LED4. HP1–HP4: Connection status indicator LED fo

4 5 AT-HD44M-RFront PanelIN: Push button for swit

DIP SWITCHSW1-SW4 for EDID/AudioDIP Switch Position Video Audio DescriptionPin#1 Pin#2 OFF OFF 1080p Stereo1Default Mode2 – 1080p & stere

6 IR Cables IR Emitter Cable IR Receiver CableIR SocketsAT-HD44M-SIR Main: The default lo